SanCloud Sancloud Beaglebone Enhanced WiFi V1G Router Login Information

To access your SanCloud Sancloud Beaglebone Enhanced WiFi V1G ( also known as BeagleBone Enhanced ) you will need the IP address and the login data (username and password).

Important: This is not the login data for your Internet service provider.

You can find this information in the Manual of your SanCloud Sancloud Beaglebone Enhanced WiFi V1G ( also known as BeagleBone Enhanced ) router. If you don't have the manual at hand or don't want to search the complete manual for the login credentials, you can use the Quick install guide which you can find below. To access the router login page it is important that you are connected to the router. Tip: If you have Wi-Fi problems and it is not possible to connect to the router, you can connect your computer and the router with a LAN cable.

Login Guide for SanCloud Sancloud Beaglebone Enhanced WiFi V1G

  • Open your preferred browser and enter acquired via DHCP in the address bar to access admin panel of your router.

    acquired via DHCP login page

  • Then you will see 2 fields where you can enter the router username and password.

    SanCloud Sancloud Beaglebone Enhanced WiFi V1G router default login

  • According to our database the default username of your SanCloud Sancloud Beaglebone Enhanced WiFi V1G router is debian and the corresponding password is temppwd.
  • Enter the username and password, click on the login button and now you should have access to the user interface of the router.

If the credentials do not work, try the following method

In the list below you can find some of the most commonly used username/password combinations of SanCloud routers. Try the following combinations. If you have problems logging in to the router or you have forgotten your password.

Username Password
debiantemppwd

The most common IPs used by SanCloud routers

You have tried several different IP addresses and still none of them work? Then you should try the IP addresses from the following list.

Default Router IP
acquired via DHCP

Nothing of the methods worked for me and I still not get access to my SanCloud Sancloud Beaglebone Enhanced WiFi V1G!

If nothing helped and you really need access to your Sancloud Beaglebone Enhanced WiFi V1G router, there is also the possibility of a factory reset. In most cases you can perform a factory reset by pressing a small button on the back of the router for 10-20 seconds. After that the router lights up and needs some minutes to reset all settings. After a factory reset the router loses the connection to all other connected devices and some devices have to be reconnected to the router after such a reset. If you are unsure, you should consult an expert to help you set up the router again.

More SanCloud routers